The Terminator simulator/trainer comes turn key ready to turn
on, and run. It is a briefcase style design, where the top half
is the terminator I/O simulator/trainer, and the bottom half is
die cut foam for the extra items needed such as power cord, power
strip etc. The two sections slide apart so the simulator/trainer
can sit upright by itself for use. When finished you can
slide the two unit's back together for easy portability.
You can substitute a Modbus, Devicenet, Profibus, or any other Terminator I/O base controller.
There is also open space in the rack to plug in any other type of card you may want to simulate.
The simulator/trainer comes with all of the items needed for the everyday technician, but if needed it can be modified to your needs. To modify this unit to fit your requirements, just call or email us with your requirements to see if we can help you out with your simulator/trainer needs.
| The trainer contains the following items. | |
| 1 | T1K-01AC (Power Supply for Terminator I/O) |
| 1 | T1H-EBC (Ethernet Base Controller) |
| 1 | T1F-08AD-2 (8 Channel Analog Input Module) |
| 1 | T1F-08DA-2 (8 Channel Analog Output Module) |
| 1 | T1K-08ND3 (8 Point DC Input Module) |
| 1 | T1K-08TR (8 Point Relay Output Module) |
| 2 | 0-10 VDC Digital Voltmeters wired to the Analog Output Module |
| 2 | Ten-turn potentiometers wired to the Analog Input Module |
| 1 | Capacitor / Resistor PID simulator build in |
| 1 | Green illuminated push button. |
| 1 | Yellow indicator light. |
| 1 | Red button. |
| 1 | Selector switch. |
| 1 | Centsable Photoeye |
| 1 | Centsable Proximity Switch |
| 1 | Power Cord (120 VAC) |
| 1 | ON / OFF switch with power cord plug in |
| 1 | 24 VDC Power Supply for customer use. ( 1.5 Amps, current limited ) |
Click on the images below for a larger view
